The 910 Roll Forming Machine is not only dignified and elegant, but also beautiful and novel. It has a flat appearance, uniform ripples, good utilization rate, high strength, good production automation degree, low cost, and long service life.
The products produced by the fully automatic 910 color steel tile press have many good characteristics, such as excellent corrosion resistance, beautiful appearance, simple processing and shaping, low cost, and wide range of uses. The products can be used in industries such as building appliances and transportation. When using the color steel tile press, the following issues should be noted:
① According to the mixing ratio notice, keep a good record of the mixing process. After stopping the operation, clean the excess material inside the machine and conveyor belt at an appropriate speed and flush it clean, keeping the surrounding area clean and hygienic.
② If construction personnel enter the mixer for inspection, they must cut off the power and have a dedicated person to supervise.
③ The construction personnel must pay attention to the safety of the operating environment, and those who are not focused cannot easily carry out operations.
④ Adjust the amount of water added to the machine according to the moisture content of the yellow sand, so that the moisture level of the mixture is appropriate, and also confirm that each mixing time should exceed two minutes.
⑤ Before starting the color steel tile pressing machine, make sure to check whether the device and electrical appliances are abnormal. Turn off the power when stopping work. When the color steel tile pressing machine is running, do not put a shovel or other objects into the mixer.
Technical parameters of 910 type color steel tile press equipment
Model: 8-130-910 Length x Width x Height 4600mm x 1300mm x 1200mm
Whole machine weight: about 2 tons
Forming shaft: diameter 70mm 45 # quenched and tempered
Forming wheel: Material 45 # forged and plated with hard chromium
Transmission mode: chain wheel, chain
Motor: 3KW
Forming rows: 9 rows
Fully automatic computer fixed length cutting system:
Pump station motor: 3KW four stage
Cutting mold: Gr12
Forming speed: 8-10m/min
Pressing thickness: 0.2-0.7mm
Compression width: 1000m